How it works
Should Your Backup Tank Feed the Garden? Sizing for Large Gardens
By the WaterQuotes team · Published 2026-11-13 · 5 min read
Garden taps are silent budget-wreckers. You fit a 5,000-litre backup tank, feel well prepared, and then someone runs the sprinklers for two hours on a hot Highveld afternoon. By dinner the gauge reads empty. If this scenario sounds familiar — or you want to avoid it — this article is for you.
The decision of whether your backup water system should feed the garden is not really about the tank. It is about demand maths and what you can afford to lose. Work through that honestly and the right answer usually becomes obvious.
How much water does a large garden actually use?
Before sizing anything, put a rough number on your garden’s demand. Lawn sprinklers typically move between 10 and 20 litres per minute depending on head type and pressure. A modest 200 m² lawn irrigated for 30 minutes could therefore consume somewhere between 600 and 1,200 litres in a single session — and that is before you count beds, trees, pots or a vegetable patch.
For reference, South Africans use on average about 237 litres of water per person per day, which is already above the world average. A family of four therefore needs roughly 950 litres a day for household purposes alone. Run that alongside even moderate garden irrigation and you can see how quickly a standard 2,500- or 5,000-litre tank disappears.
As a rough guide, a tank intended to cover both household use and a large garden for a 72-hour outage would need to be very large indeed — often 10,000 litres or more. At that point you are usually better served by two separate tanks on separate circuits.
The case for keeping the garden off the backup circuit
Municipal water is treated to SANS 241 (2024 edition) drinking-water quality. Your backup tank stores that same water, or water you have paid to have pumped and treated to a similar standard. Using it to water grass is a costly way to irrigate.
More importantly, a backup system exists to protect the household from service interruptions. The moment irrigation competes with drinking, cooking and flushing, you have compromised that protection. Johannesburg’s reservoir system holds roughly 27 hours of citywide storage buffer — not a large margin. If a disruption runs longer than that, every litre in your tank matters.
For most households the simplest and most cost-effective rule is: garden taps stay on the municipal supply line, not the backup line. When the municipality is off, the garden waits.
When a second tank for the garden makes sense
There are genuine situations where backup irrigation is worth the investment:
- You have a productive vegetable garden or food forest where losing irrigation during a prolonged outage causes real financial or nutritional loss.
- You grow specimen plants or established trees that cannot tolerate a week without water during dry season.
- You are already installing rainwater harvesting, and a garden-dedicated tank is a natural extension of that system.
- You have a borehole — read more about using a borehole for irrigation only if that route interests you, since it often changes the economics entirely.
In these cases, the approach is to size a second vessel specifically for garden demand, fed from a different source (rainwater, borehole, or a topped-up municipal fill on a separate float valve), and keep it completely isolated from your household backup circuit.
Sizing a garden tank: a practical starting point
To size a garden-dedicated tank, you need three numbers:
- Daily irrigation volume — measure or estimate from your sprinkler or drip-line flow rates and run times.
- Target autonomy — how many days without a top-up do you want to cover? Three days is a common starting point; seven is more resilient.
- A small safety buffer — add roughly 15–20% to account for evaporation, pipe losses and the occasional longer session.
Multiply daily volume by target days, then apply the buffer. If your garden uses 1,500 litres a day and you want five days of autonomy, you are looking at roughly 7,500–9,000 litres of storage as a rough guide. Confirm that figure with your installer before purchasing, since soil type, plant species and local climate all shift the number.
For help thinking through storage volumes in general, the guide on how big a water tank you need covers the core sizing logic in detail.
If you're trying to work out whether one tank or two makes more sense for your property, getting site-specific advice costs nothing. Compare 3 free quotes — vetted installers, no obligation.
Plumbing two tanks: keeping circuits clean
If you do end up with separate household and garden tanks, the plumbing must keep them genuinely separate. Cross-connections between a potable backup circuit and a rainwater or borehole garden circuit are a contamination risk and may put you outside the requirements of SANS 241.
The standard approach is to use clearly labelled, physically separate reticulation: one set of pipes from the household tank to internal fittings, a completely independent run from the garden tank to irrigation points and external taps. No shared manifolds, no shared pressure switches.
If you want your household tank to also serve external taps as a secondary function, talk to your installer about how connecting a backup tank whole-house works, and where garden taps sit in that design. It is doable, but it requires deliberate planning rather than a simple T-junction off the main feed.
Cost expectations and when to get quotes
Backup tank-and-pump systems for household use typically run R20,000–R40,000 for straightforward installations, with whole-house setups around R55,000 as a Johannesburg reference point. A second, garden-dedicated tank will add cost on top of that — the exact figure depends on tank capacity, ground conditions, the distance from the fill point to irrigation zones, and whether you need a separate pump.
There is no reliable published benchmark for garden-only tank installations because the variables are wide. Treat any number you see online as a starting point for a conversation, not a budget line.
Tank costs vary significantly by site — a quick quote from local installers gives you a real number to plan around. Get matched with installers — free, no commitment.
The honest summary
For most South African households, the garden should stay off the backup water circuit. The maths rarely work in favour of trying to cover both from one tank, and the risk of draining your household reserve on a thirsty lawn is real.
If your garden genuinely cannot tolerate interruptions, size a second tank separately, isolate the circuits, and consider a borehole or rainwater harvesting as the feed source rather than stored municipal water. That way your household backup does exactly what it is supposed to do — keep the taps running when the municipality cannot — and your garden has its own independent buffer.
Get site-specific quotes before committing to any configuration. Tank sizing, plumbing design and local installer rates vary enough that a conversation with two or three installers will tell you far more than any generic guide.
Quick answers
Can I run garden sprinklers from my backup water tank during a municipal outage?
Technically yes, if the tank is on the same circuit, but it is rarely a good idea. Sprinklers can consume hundreds of litres per session, draining a standard household tank in a matter of hours and leaving nothing for drinking, cooking or flushing. Unless you have a very large or dedicated garden tank, it is safer to leave irrigation off during outages.
How big a tank do I need to water a large garden for a week without municipal supply?
It depends entirely on your irrigation demand. As a rough starting point, estimate your daily water use from sprinkler or drip-line flow rates and run times, multiply by seven, and add about 15–20% as a buffer. For many larger gardens this calculation points to 8,000–15,000 litres or more — confirm the figure with an installer who can assess your specific setup.
Is rainwater harvesting a good way to fill a garden backup tank?
It can be, particularly for irrigation where drinking-water quality is not required. A rainwater tank feeding garden circuits only keeps costs and treatment requirements lower than a potable backup system. The practical limitation is that rainfall in many parts of South Africa is seasonal, so storage capacity needs to reflect the dry months, not just the wet ones.
Do I need to tell my insurer or municipality if I install a second tank for garden use?
Requirements vary by municipality and policy, so check both. Some municipalities require notification or a permit for large tank installations or borehole connections. Your insurer may also want to know about significant plumbing changes. It is worth confirming before installation rather than after.
What is the risk of connecting a rainwater garden tank to the same pipes as my household backup?
Cross-connecting a non-potable source (rainwater or borehole) to a potable backup circuit creates a contamination risk and may put you outside SANS 241 compliance requirements. Installers should plumb the two systems as genuinely separate circuits with no shared manifolds or pressure switches. Always confirm the design with a qualified installer who understands local water quality standards.
Sources & notes
Pricing reflects typical Johannesburg market ranges and is confirmed by installer quotation. References: SABS
Ready to compare? Get up to 3 quotes from vetted backup water systems installers in Johannesburg — free, no obligation.
Get 3 free quotes